|
How do I change the seismograph's date/time? |
|
The method depends on the instrument's firmware. If you see the words CLOCK OK
on the screen showing the current date and time do the following: |
- Make sure you are on the screen showing the words CLOCK
OK.
- Press SHIFT and + until the word OK is bracketed.
- Press + to change the word to SET.
- Press ENTER. This will show a screen with the
current date and time.
- Press SHIFT and + until the field value you want to
change is bracketed.
- Press + or - to increase or decrease the value.
- Repeat steps 5 and 6 as needed.
- Press ENTER to accept. Do not bracket the EXIT and
press ENTER as that will cancel the changes.
|
|
If you do not see the words CLOCK ON the follow this procedure: |
- Make sure you are on the screen showing the current date and time in the lower
right of the display.
- Press SHIFT and + until the field value you want to change is bracketed.
- Press + or - to increase or decrease the value.
- Repeat steps 2 and 3 as needed.
- Press ENTER to accept.
|